Doorbell with Four Buttons and Name Tag Frames
Item No. 454
A classically decorated, narrow doorbell plate with four bell buttons and frames for nameplates. It is typically mounted using two pre-drilled holes. The bell contacts for flush mounting protrude approximately 1-1.5 cm from the rear.
We can also produce this doorbell plate with only three bell buttons and frames, or alternatively, we can extend it to accommodate more bell buttons.
We can also produce this doorbell plate with only three bell buttons and frames, or alternatively, we can extend it to accommodate more bell buttons.
| Engraved brass name plates | An engraved brass plate with block or script letters for this doorbell is available at 15.00 USD each. Order now |
|---|
Each item is painted and patinated by hand to order. You can specify whether you prefer a subtle or more pronounced patina, or whether you would like the decorative contours to stand out more clearly.
We use high-quality protective metal paints and primers. Minor damage to the finish can be touched up if necessary.
We use high-quality protective metal paints and primers. Minor damage to the finish can be touched up if necessary.
View all available colours.
Specifications of the bell buttons:
 |
Push-button material: Black plastic Push-button diameter: Ø 10 mm Overall diameter: 18 mm |
|---|---|
 |
Push-button material: Aluminium-coloured Push-button diameter: Ø 11.5 mm Overall diameter: 22 mm |
 |
Push-button material: Black plastic Push-button diameter: Ø 11.5 mm Overall diameter: 22 mm |
| Maximum switching capacity: | 12 V AC/DC 1.5 A |
| Minimum switching capacity: | 5 V / 1 mA |
| Wire diameter: | 0.6 to 0.8 mm |
| Switching travel: | 0.8 mm to 2 mm |
| Total operating travel: | 1.2 mm to 3 mm |
| Operating temperature: | −20 °C to +60 °C |
| Protection rating: | IP54 when installed in a vertical plate |
The bell contacts must be connected to an existing doorbell system. A bell transformer, chime and intercom equipment are not included.
You might also be interested in
